I2C Information

The I2C interface should be enabled with raspi-config or from the [Gear Icon] -> Configure -> Raspberry Pi page.

1-Wire Information

The 1-Wire interface should be enabled with raspi-config or from the [Gear Icon] -> Configure -> Raspberry Pi page.

UART Information

This documentation provides specific installation procedures for configuring UART with the Raspberry Pi version 1 or 2.

Because the UART is handled differently higher after the Raspberry Pi 2 (due to the addition of bluetooth), there are a different set of instructions. If installing Mycodo on a Raspberry Pi 3 or above, you only need to perform these steps to configure UART:

Run raspi-config

sudo raspi-config

Go to Advanced Options -> Serial and disable. Then edit /boot/config.txt

sudo nano /boot/config.txt

Find the line "enable_uart=0" and change it to "enable_uart=1", then reboot.