JJérôme Forissierdrivers: clk: sam: export audiopll_fracck and usbck
| 文件 | 最后提交记录 | 最后更新时间 |
|---|---|---|
drivers: clk: sam: export audiopll_fracck and usbck This allows to modify the clocks rate and parents from the device-tree using assigned-clock-parents/rate properties rather than hardcoding the clocks rate. Signed-off-by: Clément Léger <clement.leger@bootlin.com> Acked-by: Etienne Carriere <etienne.carriere@linaro.org> | 3 年前 | |
dts: at91: add device trees for sama5d2_xplained Import device-tree from linux for sama5d2 and relicense them with dual GPL/BSD 3-Clause Acked-by: Etienne Carriere <etienne.carriere@linaro.org> Acked-by: Nicolas Ferre <nicolas.ferre@microchip.com> Signed-off-by: Clément Léger <clement.leger@bootlin.com> | 4 年前 | |
dt-bindings: gpio: add GPIO_PULL_{UP,DOWN} definitions This is required to bump stm32mp15 dts(i) files to Linux 5.19-rc6. Signed-off-by: Johann Neuhauser <jneuhauser@dh-electronics.com> Reviewed-by: Etienne Carriere <etienne.carriere@linaro.org> | 3 年前 | |
dts: at91: add device trees for sama5d2_xplained Import device-tree from linux for sama5d2 and relicense them with dual GPL/BSD 3-Clause Acked-by: Etienne Carriere <etienne.carriere@linaro.org> Acked-by: Nicolas Ferre <nicolas.ferre@microchip.com> Signed-off-by: Clément Léger <clement.leger@bootlin.com> | 4 年前 | |
stm32mp1: device tree platform description This change introduces the device tree source files describing boards EV1 and ED1 and the related bindings. The stm32mp1 DTS files and bindings header files are dumped from latest Linux kernel (v4.19). Bindings documentation is not stored in OP-TEE OS source tree, one shall refer to the bindings documentation from latest Linux kernel source tree. Note that license terms where changed for binding header file gpio.h to release them under dual 2-Clause DSB/GPLv2.0 instead of GPLv2.0 as release in the Linux kernel. Platform relies on DT source file (CFG_EMBED_DTB_SOURCE_FILE) to distinguish between the platform flavors for the few configuration directive that are static and cannot be provided only through FDT. Default configuration locates the secure DDR area (TZDRAM) from the base address of the last 32MBytes of the DDR over 30Mbyte. The last 2MBytes of the DDR are the OP-TEE static shared memory. Many contributors not listed below. Signed-off-by: Etienne Carriere <etienne.carriere@st.com> Acked-by: Jerome Forissier <jerome.forissier@linaro.org> | 7 年前 | |
dts: at91: add device trees for sama5d2_xplained Import device-tree from linux for sama5d2 and relicense them with dual GPL/BSD 3-Clause Acked-by: Etienne Carriere <etienne.carriere@linaro.org> Acked-by: Nicolas Ferre <nicolas.ferre@microchip.com> Signed-off-by: Clément Léger <clement.leger@bootlin.com> | 4 年前 | |
dt-bindings: update stm32-pinfunc.h Update DT bindings for stm32 pin control with the Linux kernel v5.6.10 on which we want to synchronize DTS file with. Signed-off-by: Etienne Carriere <etienne.carriere@st.com> Acked-by: Jerome Forissier <jerome@forissier.org> | 6 年前 | |
dt-bindings: add STM32MP13 regulator bindings These bindings will be used for the SCMI voltage domain. Signed-off-by: Pascal Paillet <p.paillet@foss.st.com> Signed-off-by: Gatien Chevallier <gatien.chevallier@foss.st.com> Acked-by: Etienne Carriere <etienne.carriere@linaro.org> Acked-by: Jens Wiklander <jens.wiklander@linaro.org> | 3 年前 | |
dt-bindings: define system reset controller for stm32mp1 flavors Define DT binding ID related to system reset controller, for both STM32MP15 and STM32MP13 variants. Acked-by: Jens Wiklander <jens.wiklander@linaro.org> Signed-off-by: Etienne Carriere <etienne.carriere@linaro.org> | 3 年前 |